Use monitor touch controls to adjust settings while framing pictures in the viewfinder.
- Touch Fn is available only when the monitor is in storage position with the screen facing outward.
Enable/disable touch Fn
Select [ON] to enable touch Fn.
Assign touch Fn
The roles that can be assigned to touch Fn are listed below.
| Role | Description |
|---|---|
| [Move focus point] | The focus point can be positioned by sliding a finger over the touch Fn area. You can set the operation for when you give two quick taps during focus point selection. Setting [Select center focus point] selects the center focus point. Setting [Set absolute focus position] selects the focus point position that was tapped. |
| [Switch eyes] | When the camera detects the eyes of a human or animal portrait subject, you can choose the eye used for focus by tapping the touch Fn area in the monitor. |
| [Framing grid] | Tapping the touch Fn area in the monitor displays a framing grid in the viewfinder. Tap again to hide the grid. The grid type can be selected using Custom Setting d16 or g14 [Grid type]. |
| [Zoom on/off] | Tap the touch Fn area in the monitor to zoom the display in the viewfinder in on the area around the current focus point. Tap again to cancel zoom.
|
| [Virtual horizon] | Tap the touch Fn area in the monitor to enable the virtual horizon display in the viewfinder. Tap again to hide the display. The display type can be selected using Custom Setting d17 [Virtual horizon type]. |
Touch Fn area
Choose the area of the monitor used for touch Fn. The areas for use when the camera is rotated to take pictures in “tall” and “wide” orientations can be selected separately.