Adjust status LED and link mode settings for optional WR-R11a and WR‑R10 wireless remote controllers. You can also choose a link mode for connection to optional radio-controlled flash units that support Advanced Wireless Lighting.

WR-R10 Wireless Remote Controllers
  • A WR-A10 adapter is required when using the WR-R10.

  • Be sure the firmware for the WR-R10 has been updated to the latest version (version 3.0 or later). For information on firmware updates, see the Nikon website for your area.

LED Lamp

Enable or disable the status LEDs on the WR-R11a or WR-R10 wireless remote controller mounted on the camera. For more information, see the documentation supplied with the wireless remote controller.

Choose a link mode for WR-R11a or WR-R10 wireless remote controllers mounted on other cameras or radio-controlled flash units that support Advanced Wireless Lighting. Be sure that the same mode is selected for the other devices.

Option

Description

[Pairing]

The camera connects only to devices with which it has previously been paired. Press the pairing button on the wireless remote controller connected to the camera to pair it with other devices.

  • As camera will not communicate with devices with which it has not been paired, this option can be used to prevent signal interference from other devices in the vicinity.

  • Given that each device must be paired separately, however, PIN is recommended when connecting to a large number of devices.

[PIN]

Communication is shared among all devices with the same four-digit PIN. Enter a four-digit PIN of your choosing. Press 4 or 2 to highlight digits and press 1 or 3 to change. Press J to enter and display the selected PIN.

  • This option is a good choice for photography featuring a large number of remote devices.

  • If there are multiple cameras present that share the same PIN, the flash units will be under the sole control of the camera that connects first, preventing all other cameras from connecting (the LEDs on the wireless remote controllers connected to the affected cameras will blink).

  • Regardless of the option selected for [Link mode], signals from paired wireless remote controllers will always be received by the WR-R11a or WR-R10. Users of the WR-1 wireless remote controller will need to select pairing as the WR-1 link mode.